IBM DataPower Operations Dashboard v1.0.16.0

A newer version of this product documentation is available.

You are viewing an older version. View latest at IBM DPOD Documentation.

Service Configuration Changes

The Service Configuration Changes tab in the Explore view lists all changes made to the services ordered by time descending.

These may be changes to the gateway's services, front-side handlers, B2B Gateways and B2B Partners.
DPOD queries the gateway every 30 minutes for all services' configuration (the interval may be changed from the system parameters page), compares the result with the previous configuration and stores a change audit record when changes are found.

The Change Audit is displayed in a table, where each row describes a single change:

ColumnDescription

Device

The device the service is configured on.
Click on the device name to apply a device-filter to the table.

Domain

The domain the service is configured on.
Click on the domain name to apply a domain-filter to the table.

Service Name

The name of the service.
Click on the service name to apply a service-filter to the table.

Time SampledThe change’s timestamp sampled by DPOD
Change Operation

The change operation (for B2B Gateway objects the change operation will also contain the B2B partner's name if applicable).

For example - 
"Replaced in FSH" for an attribute that was changed in a the front-side handler
"Removed in Service" for an attribute that no longer exists in a Service 

The "Discovered" operation describes when the service/FSH was first discovered by DPOD, and not the time it was originally created

Description

Description of the change

For example - 
User Comments was changed from old text to new text
Admin State was changed from enabled to disabled

Latency Change

The change in latency (percentage)  before and after the configuration change. The time interval before and after can be set by the Latency/Error filter (4 hours, 1 day, 1 week).
n/a will be displayed if there were no executions of the service.

Error ChangeThe change in errors (percentage) before and after the configuration change. The time interval before and after can be set by the Latency/Error filter (4 hours, 1 day, 1 week).
n/a will be displayed if there were no errors before or after the change.




IBM DataPower Operations Dashboard (DPOD) v1.0.16.0