| Note |
|---|
Monitoring transactions in the default domain will limit the maximum monitored TPS for the device to 1000 (where hardware permits such capacity) |
...
Support TX in the Default Domain
When the option is disabled - the rest of the screen will look like, and behave as described on in the add monitored devices page, transactions in the default domain will not be monitored.
When the option is enabled - the screen will behave as described below.
The operation may take a few minutes.Info Changing this option will immediately remove all of DPOD's log targets from the monitored device.
If the device was already monitored - you will need to setup syslogs for all domains again, just changing this option is not enough.Setup Syslog for All Domains - Select the desired Analysis Level, select the Syslog agent and click "Setup Syslog", the operation may take a few minutes
Info Monitoring transactions in the default domain will cause all domains in the monitored device to report to the same DPOD syslog agent, it is not possible to choose a different syslog agent per domain. Info The "Auto Setup Domains" option is redundant and is not available when monitoring transactions in the default domain , - all new domains will be monitored automatically.. - Domains WS-M Setup (Optional) - If you wish to record and view payloads, or to record API-C policy variables, select the desired WS-M Agent according to the architecture design and click "Setup WS-M”, the operation may take a few minutes.
For supported WS-M payload capture services see IDG WS-M payload capture support.
Click on "Record Payload" to open the payload capture page where you can start capturing payloads - Certificate Monitor Setup (Optional)
If you wish to use DPOD's expired certificate dashboard, click on "Setup Certificate Monitor"
Consult the System Parameters List ("Certificate monitoring duration in days") for information regarding the time interval parameter.