Page Comparison

...

1. Stop DPOD components 

2. Ensure all components are down

3. Disable all DPOD services except Derby, UI and Reports:

   1. Edit (using vi) the file /etc/sysconfig/MonTier ,change the following line:

      Code Block
      SERVICES_FIRST_GROUP="MonTier-Derby MonTier-es-raw-trans-Node-1"

      and remove all components except for MonTier-Derby:

      Code Block
      SERVICES_FIRST_GROUP="MonTier-Derby"

      
      

   2. Comment out the following lines:

      Code Block
      SERVICES_SECOND_GROUP="MonTier-es-raw-trans-Node ..." SERVICES_FORTH_GROUP="MonTier-AggAgent- ..." SERVICES_FIFTH_GROUP="MonTier-BalancerAgent ..." SERVICES_SIXTH_GROUP="MonTier-WsmAgent-1 ..."

      The following line should be left as is:

      Code Block
      SERVICES_THIRD_GROUP="MonTier-HK-ESRetention "

      
      

4. Change

   the following line:

   Code Block
   SERVICES_SEVENTH_GROUP="MonTier-UI MonTier-Reports MonTier-HK-WsmKeepalive MonTier-HK-SyslogKeepalive"

   and remove all components except MonTier-UI and MonTier-Reports:
   

   Code Block
   SERVICES_SEVENTH_GROUP="MonTier-UI MonTier-Reports"

   Change DPOD's Store entries in /etc/hosts to direct to DPOD Internal Console IP address (1.1.1.1 in the example below):

   Code Block
   1.1.1.1 montier-es 1.1.1.1 montier-es-http

   
   

5. Start configuration database service

   Code Block
   start_services.sh -o derby ij

   
   

6. Update the SystemParameter SQL table:

   Code Block

   UPDATE SystemParameter SET value='false' WHERE name='agents.management.enabled'; UPDATE SystemParameter SET value='false' WHERE name = 'system.internal_self_service.is_internal'; UPDATE SystemParameter SET value='false' WHERE name = 'system.should_run_retention_on_startup'; update HATSRECURRINGTASK set isEnabled='false' where taskType not in ('DATABASE_CLEANUP', 'FILE_CLEANUP', 'INTERNAL_ALERTS_CHECK_DERBY', 'INTERNAL_ALERTS_CHECK_FS_FREESPACE');

   
   

7. If you wish to let the external self service users access the DevOps Services Portal, change the following system parameters in the external self service console
   (you can do that from Manage → Customize → System Parameters after the web console starts):
   1. Internal Self Service Address: Enter the address of the internal self service portal.
   2. Internal Self Service Webserver Port: (defaults to 443) The webserver port for the internal self service portal - change this value only if advised.
   Update retention config file (/app/hk_retention/MonTier-HK-ESRetention/conf/MonTierHousekeeping
   1. .
   conf) and set the following parmeter to false: Code Blockhats.interact.enabled = false

DPOD Internal Console Post Installation Tasks

...