IBM DataPower Operations Dashboard v1.0.16.0

A newer version of this product documentation is available.

You are viewing an older version. View latest at IBM DPOD Documentation.

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Current »


The "Manual Configuration" page outlines manual setup you'll may need to perform after the secure restore to the target gateway was done:

  • Non-mgmt network interfaces should be still disconnected at the target gateway.
    To enable applicative traffic on the target gateway, please configure the source gateway's and/or target gateway's network interfaces in a way that will not cause IP address collisions.
  • If the source gateway was part of an API-Connect gateway cluster, you might need to make API-Connect aware of the migration by removing the gateway from the cluster and adding it back again.
  • No labels

IBM DataPower Operations Dashboard (DPOD) v1.0.16.0