ex-raw-trans

The general state of the Big Data store.

• GREEN – Everything is working properly.

• YELLOW – System is up and running, but there’s a problem requiring your attention (e.g. one of the nodes is down, but another node took over).

• RED – There is a major problem with the Big Data store. DPOD is malfunctioning. Contact the support team.

Note: During the first 10-20 minutes following a system startup, a value of YELLOW or RED is normal.

GREEN

(RED and YELLOW acceptable during startup)

Shards

Details of the allocation of logical data to physical storage in the Store. All shards should be assigned, and unassigned shards number should be 0.

Note: During the first 10-20 minutes following a system startup, a value greater than zero is normal. 

If unassigned shards persist, see Error Accessing Store - Unassigned Shards.

0 Unassigned shards

(A larger than 0 value acceptable during startup)

Store Button

The Store button may be used for troubleshooting and for inspecting the data that is stored in DPOD Store. When required, DPOD support team will guide you through the usage of this button.

Name

Index set name.

Indices Count

The number of indices within that index set that currently exist.

There should be at least 1 index for each index set, and most index sets should contain between 1 and 20 indices. However, in case the storage allocated to DPOD is big enough (a few TB), the indices count for wdp-syslog* might reach a couple of hundreds of indices.

1-20 for most index sets

1-300 for Syslog indices when storage allows.

Size

Total size of the index set.

Greater than 0 for most index sets, depending on your usage.

Translog Size

Size of a temporary translog used by the active index for improved indexing performance.

Less than 1 GB

Documents Count

Total documents (such as Syslog messages, resource sampling, etc.) of the index set.

Some index sets might contain 0 documents, if certain features are not in use in DPOD.

Greater than 0 for most index sets, depending on your usage.

Oldest Document Time

Oldest record in the index set. Verify that this fits your requirements, and if not – you may need to Increase Storage for Index Sets.

As per your requirements.

Newest Document Time

Newest record in the index set. Verify that this fits your requirements, and if not – you may need to Increase Storage for Index Sets.

As per your requirements.

Index Set Name

Description

apic-log

Contains transactional API-C data collected by the Syslog agents from monitored devices. This is the primary source of information for API-C product view dashboards and investigation.

wdp-config-service

Contains sampled configuration data about DataPower Gateway services. This is the primary source of information for the Explore section in Gateway product view.

wdp-device-resources

Contains samples of device resources, e.g.: monitored devices CPU, memory, hardware state, etc.

wdp-service-resources

Contains sampled service resources, e.g.: memory consumption by monitored services, etc.

wdp-syslog

Contains log records collected by the Syslog agents from monitored devices, except system messages, e.g.: transaction started, network call states, integration code errors, etc.

wdp-syslog-sys-*

Contains log records of system events collected by the Syslog agent from monitored devices.

wdp-wsm

Contains payload message collected by the WS-M agent when WS-M payload capture is enabled.

Name

Node Name

Version

Node Version

All versions should be the same

Host Name

Node's host name

Type

A correctly set up system should have at least one ‘D’ node (data processing node),
and an odd number of ‘M’ nodes (master nodes).

• D Nodes > 0

• Odd M Nodes number