This section details the port configuration setup required between DPOD and the your network components.

From	To	Ports (Defaults)	Protocol	Usage
DPOD Appliance	Each Monitored Device	5550 (TCP)	HTTP/S	Monitored Device administration management interface
DPOD Appliance	DNS Server	TCP and UDP 53	DNS	DNS services
DPOD Appliance	NTP Server	123 (UDP)	NTP	Time synchronization
DPOD Appliance	Organizational mail server	25 (TCP)	SMTP	Send reports by email
DPOD Appliance	LDAP	TCP 389 / 636 (SSL). TCP 3268 / 3269 (SSL)	LDAP	Authentication & authorization. Can be over SSL
NTP Server	DPOD Appliance	123 (UDP)	NTP	Time synchronization
Each Monitored Device	DPOD Appliance	60000-60009 (TCP)	TCP	SYSLOG Data
Each Monitored Device	DPOD Appliance	60020-60029 (TCP)	HTTP/S	WS-M Payloads
FROM Users IPs	DPOD Appliance	443 (TCP)	HTTP/S	Access to with IBM DataPower Operations Dashboard Console
FROM Admins IPs	DPOD Appliance	22 (TCP)	TCP	SSH

Special consideration for Docker container Light Development Edition:

Based on the DPOD Docker run command - setup the needed port configuration to communicate with the Docker host (The Docker host is the server with the Docker engine that runs the DPOD container. referred to on the DPOD Docker documentation as DPOD_EXT_HOST_IP ) .
The values in the following table are based on the documentation defaults.

From	To	Ports (Defaults)	Protocol	Usage
DPOD Docker host	Each Monitored Device	5550 (TCP)	HTTP/S	Monitored Device administration management interface
DPOD Docker host	Organizational mail server	25 (TCP)	SMTP	Send reports by email
Each Monitored Device	DPOD Docker host	60000-60009 (TCP)	TCP	SYSLOG Data
Each Monitored Device	DPOD Docker host	60020-60029 (TCP)	HTTP/S	WS-M Payloads
FROM Users IPs	DPOD Docker host	443 (TCP)	HTTP/S	Access to with IBM DataPower Operations Dashboard Console
FROM Admins IPs	DPOD Docker host	9022 (TCP)	TCP	SSH

Browser not supported