This is the default view when you click to open the Investigate process. It provides details of the transactions in the system, according to the filters set.

Filters

See Available Filters for a complete list of filters.

Transactions Grid

The following information is available for each transaction:

Column	Description
Service Name	The service the running the transaction. Clicking the service name link applies a service filter to the results, showing only transactions across this service
Operation	The operation type of this transaction (may show the Request URI for Multi-Protocol Gateway services)
Time	The time this transaction was logged
Device	The device this transaction ran on. Clicking the device name link applies a device filter to the results, showing only transactions that ran on this device.
Domain	The domain this transaction ran in
Status	The status of the transaction. This may be either OK, ERROR or INPROCESS
Trans Id	This is the monitored device's transaction id. Clicking the Transaction id link loads the Single Transaction details view
Client IP	The client originating the transaction. This can sometimes be the IP of the load balancer.
Elapsed (ms)	The elapsed time of the transaction in milliseconds
Payload	When WS-M recording is on, this column will contain the payload of the transaction.

Note

IN PROCESS transactions may or may not have completed OK. INPROCESS signifies that DPOD has not found an ‘End transaction’ message in the log for this transaction.

Browser not supported