This is the default view when you click to open the Investigate process. It provides details of the transactions in the system, according to the filters set.

Filters

The filters screen the data that is passed at the beginning of the API execution except OAuth, Latency, Response codes and Error messages which are collected at the end of the transaction.
If the API did not finish, the OAuth, Latency, Response codes and Error message will not be collected and will not be displayed in the grid.

Transactions Grid

The following information is available for each transaction:

Column	Description
API Name	The API Name
Time	The time this transaction was logged
Device	The device this transaction ran on. Clicking the device name link applies a device filter to the results, showing only transactions that ran on this device.
Catalog Name	The API Catalog Name
Space Name	The API Space Name
Operation ID	The invoked operation within the API
Client ID	The ID of the client that invoked the API
OAuth Scope	OAuth Scope
Status	The status of the transaction. This may be either OK, ERROR
Trans ID	This is the monitored device's transaction ID. Clicking the Transaction id link loads the Single Transaction details view
Client IP	The client originating the transaction. This can sometimes be the IP of the load balancer.
Gl. Trans. ID	The global transaction ID
Elapsed (ms)	The elapsed time of the transaction in milliseconds
Payload	When WS-M recording is on, this column will contain the payload of the transaction.

Browser not supported