IBM DataPower Operations Dashboard v1.0.22.x
Firewall Requirements for Docker Container
- Amit Munwes
Based on the DPOD Docker run command, setup the needed port configuration to communicate with the Docker host (the Docker host is the server with the Docker engine that runs the DPOD container, referred to on the DPOD Docker documentation as DPOD_EXT_HOST_IP). The values in the following table are based on the documentation defaults.
It is highly recommended to block any traffic that does not comply to the firewall rules listed below.
From | To | Ports (Defaults) | Protocol | Usage |
|---|---|---|---|---|
DPOD Docker host | Each DataPower Gateway | 5550 (TCP) | HTTPS | DataPower Gateway administration SOAP management interface. If the SOMA port is different than 5550 - the port should be changed accordingly. |
5554 (TCP) | HTTPS | DataPower Gateway administration REST management interface. If the ROMA port is different than 5554 - the port should be changed accordingly. | ||
DPOD Docker host | Organizational mail server | 25 / 465 / 587 (TCP) | SMTP/S | Send reports/alerts/shares/etc. by email |
Each DataPower Gateway | DPOD Docker host | 60000-60003 (TCP) | Syslog | Syslog data |
60020-60023 (TCP) | HTTP | WS-M payloads (optional) | ||
API-Connect Analytics Ingestion Pods | DPOD Docker host | 60020-60023 (TCP) | HTTP/S | API-Connect Analytics Offload (optional) |
DPOD Users IPs | DPOD Docker host | 443 (TCP) | HTTPS | DPOD's Web Console |
DPOD Server Admins IPs | DPOD Docker host | 9022 (TCP) | SSH | SSH |
Â
Copyright © 2015 MonTier Software (2015) Ltd.