Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  • Since the DataPower gateway currently supports up to 1,000 log targets, DPOD can monitor a maximum of 333 domains per each gateway, if no other custom log targets are defined. See details and calculation below for more information.
    This limitation is per each DataPower gateway and has no effect on the number of gateways that can be connected to DPOD.

  • The total amount of log targets per each DataPower gateway cannot exceed 1,000 and consists of:

    • One required default log target per domain (created when the domain is created with the name default-log), which cannot be removed.

    • Additional custom log targets, created by the customer for non-DPOD use.

    • Log targets created by DPOD - DPOD will create one log target for the default domain, and 2 log targets for each monitored application domain.

  • Before you enable DPOD monitoring:

    • Count how many domains should be monitored by DPOD (except the default domain) - DOMAINS_COUNT

    • Count how many log targets already exist in the DataPower gateway - EXISTING_LOG_TARGETS_COUNT
      You can view the existing log targets in the DataPower gateway WebGUI under default domain → Log Target Status → Show All Domains

    • Make sure the following calculation is true:

      Code Block
      EXISTING_LOG_TARGETS_COUNT + (DOMAINS_COUNT x 2) + 1 < 1,000
  • Known workarounds: If the number of expected log targets exceeds the limit, do not enable DPOD monitoring. You may use the following methods to allow for DPOD monitoring:

    • Reduce the amount of monitored domains by setting up monitoring only for selected domains (see Configuring Monitored Gateways).

    • Delete unused domains or move domains to another gateway.

    • Delete unused custom log targets that were created for non-DPOD use.

...