...
When Installing DPOD from an ISO file, The first step is to instal install the Appliance which means install and configure the OS preloaded Pre-loaded on the ISO (CentOS).
Completing the steps below will create a DPOD-ready appliance to install DPOD's software on.
...
OS Installation
- Set DPOD ISO file on you Server your server (virtual or Physical) DVD.
- Power on the Physical (or Virtual) server.
On the OS launch screen, choose “Install Appliance” to start the automatic OS installation.
: 
change diagram to new-namec
The required packages will now be installed. Wait for the installation to complete before proceeding.
...
When the OS installation completes, you will be presented with the Network Configuration screen, used to provide DPOD with the network information it requires.
odo: change diagram to new-name
- Enter DPOD's host name, e.g. DPOD-2
(You may add this name to your organization's DNS) - Enter the IPv4 address, e.g. 192.168.65.170
- Enter the network netmask, e.g. 255.255.255.0
- Enter the default gateway: e.g. 192.168.65.2
- Enter primary and secondary DNS server IP addresses (not mandatory)
...