Versions Compared

Version Old Version 22 New Version 23
Changes made by

Hanan Kenan

Amit Munwes

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Warning

You MUST NOT add or install any packages / RPMs at DPOD's installation time (or after install installation completes) unless instructed by support.

You MUST NOT update the CentOS version or any other component within DPOD using external repositories (for example: , do not use yum update).

The only supported way to upgrade the platform and/or component components is by apply applying a product Fix Pack.

OS Installation

  1. Set DPOD ISO file on your server (virtual or Physical) virtual/physical server's DVD.
  2. Power on the Physical (or Virtual) servervirtual/physical server.

On the OS launch screen, choose “Install Appliance” to start the automatic OS installation for Standard Edition.
: c

The required packages will now be installed. Wait for the installation to complete before proceeding .

Image Removed

(This this should take a few minutes).

Image Added


Note

Light Edition should have different launch screen that state stating this is a Light Edition. Rest The rest of the steps are the same

...

When the OS installation completes, you will be presented with the Network Configuration screen, used to provide DPOD with the network information it requires. 

  1. Enter DPOD's host name, e.g.  DPOD-2
    Image Removed
    (You dpod25min (you may add this the host name to your organization's DNS).
  2. Enter the IPv4 address, e.g. 192.168.65.170
  3. Enter the network netmask, e.g. 255.255.255.0
  4. Enter the default gateway: e.g. 192.168.65.2
  5. Enter primary and secondary DNS server IP addresses (not mandatory)

Image Added

When the network data entry process is complete, DPOD echoes it back on the screen for verification and displays an 'Is this correct [y/n]' prompt.
Enter “y” to confirm network details as entered or “n” to re-enter the information.

DPOD NTP Configuration

On the next screen you configure the NTP (Network Time Protocol) servers DPOD is going to use. Keeping the internal clocks of DPOD and the monitored appliances in sync is important - as DPOD reports the time as logged by the devices themselves. 

Image Removed

Enter your NTP servers information

  1. DPOD displays a 'Do you want to continue with NTP configuration' prompt. Enter "y" to continue with NTP configuration or "n" to skip.
  2. Enter at least one NTP server (more then 2 is recommended )

After you finish entering the NTP data, DPOD echoes it back on the screen for verification and displays an 'Is this correct [y/n]' prompt. 
Enter “y” to confirm NTP details as entered or “n” to re-enter the information.

...

If you reject the proposed time zone,you will nee to select the right one for you.

  • Enter the current date and time in the format of YYYY-MM-DD hh:mm:ss, for example: 2016-11-10 14:00:00

...