Install DPOD Light Edition
The Developer (light) Edition's aim is aim to assist the Technical presale, . It is geared towards the DataPower developer that want to assist wants to run DPOD on their Development Workstation and limited functional , in the context of limited functionality Proof Of Concept. This installation will not allow multi-node configuration and is not planned to support any performance of more than 2-3 TPS.
What are the major differences?
...
The Developer Edition is identical to the
...
GA Edition and has all of its components.
...
It differs in the following aspects:
- Less HW
- Hardware & SW
- Software requirements
- Limited configuration
- One extra post installation step
How to Identify a Light Edition installation?
The following can be used to identify a Developer edition
...
:
- The ISO filename should be IBM_DataPower_OpDashboard_Dev<version>.iso
- The CentOS installation screen will show Developer Edition One
- A single configuration setup for development that exists only in the Development ISO file !
- .
Less Hardware and Software Requirements
Load Type | Goal | TPS Limits recommended | Supports Virtual Env | Cores (1) | Memory (3) | Storage (GB) |
Developer (Light Edition Only) | To support evaluation, POCs and DPOD development | 5 | Yes | 2 | 3 GB | All: 15GB |
(1) These could be cores on an 80% utilized ESXi
...
(3) Best query performance is achieved by using reserved memory configuration
Limited Configuration
Limited configuration is available in The Developer Edition which allows only limited configuration. This means only 1 a single type of architecture configuration file that will provide provides a single DPOD node architecture and 1-2 agents only for WS-M and syslogs. You will need to choose it in the Software Deployment Chapter in section in the product documentation.
One Extra installation step
When perform all following the steps listed in the Software Deployment Chapter in section of the product documentation, you are required to perform this an additional step :9. Configure system to use Minimize Resource Consumption.(step #9 in the list)
to configure the system to minimize resource consumption:
- Run the following script to complete the development environment installation (Run This script only once!)
- You will be prompt to approve the script invocation
...