...
- Under "Syslog Setup for Device", select the correct Syslog Agent according to the architecture design, click "Setup Syslog for device" and wait until the action completes successfully.
Syslog setup for all domains
- Under "Syslog Setup for All Domains", select the correct Syslog Agent according to the architecture design, click "Setup Syslog for all domains" and wait until the action completes successfully.
todo:change
diagram to new-name
| Tip | ||
|---|---|---|
| ||
Domains may be redirected to different Syslog agents according to the architecture design. If this is the case, set up each domain separately as documented below |
...
Auto Setup Domains (Optional)
- Under "WS-M Setup for Device", click "Setup WS-M for all domains" and wait until the action completes successfully.
- Note: You may elect to only enable WS-M for specific domains. If this is the case, setup each domain separately as documented below.
...
This feature will automatically detect and setup new domains created on the monitored device, this is especially useful for dynamically created API Connect domains.
Choose a Syslog agent that the domains should report to, enter the domain pattern (use asterisk as wildcard) and click save.
DPOD will scan the monitored device every 2 minutes and will setup the new domain - you can change the interval from the system parameters page. (A UI service restart is required after changing this interval)
Domains WS-M Setup (Optional)
Under "Domains WS-M Subscriptions for All DomainsSetup", select the correct WS-M Agent according to the architecture design, click "Subscribe to Setup WS-M for all domains” M” and wait until the action completes successfully.
A WS-M subscription will be created for each domain where one is not already created by DPOD.
For supported WS-M payload capture services see IDG WS-M payload capture support
Consult System Parameters List for information regarding the time interval parameter.
| Tip |
|---|
This feature can be used at a service or domain level. |
| Warning |
|---|
This step will start recording payloads of transactions for a specific amount of time (1 hour is the default configuration). You may run this later when you need payloads recorded. You may choose to record payload for a specific domain. If this is the case, please subscribe each domain separately as documented below. |
Click on "Record Payload" to go to the payload capture page where you can start capturing payloads
Extended Transaction setup (Optional)
...
| Warning |
|---|
This step will MODIFY SERVICES PROCESSING POLICY. You must test and verify the services are not affected by this change before setting this up on production environments. |
| Tip |
|---|
This feature can be used at a service or domain level. |
...
Consult System Parameters List for information regarding the time interval parameter.
Domain Level Configuration
...