...

1.  Inside DPOD's Web Console, navigate to Monitored Devices  [Manage->Devices->Monitored Devices] and click on “Add Device”
2. Enter the information required. (Consult Device Management for details)
   Note that the device name must be identical to the System Identifier/Appliance Name of the DataPower Gateway as set in the IDG itself, and must meet the requirements detailed in http://www-01.ibm.com/support/docview.wss?uid=swg21668456.
   
   
   
   
3. Click “Add”
4. DPOD will add the device. (Verify by locating the new device in the list of monitored devices)
   
   

...

This feature will automatically detect and setup new domains created on the monitored device, this . This is especially useful for dynamically created API Connect domains.
Choose Select a Syslog agent that the domains should report to, enter the domain pattern (use asterisk as wildcard) and click save.
DPOD will scan the monitored device devices every 2 minutes and will setup the new domain - you can . You may change the scan interval from on the system parameters page. (A UI service restart is required after changing this interval)

...

Under "Domains WS-M Setup", select the correct WS-M Agent according to the architecture design, click . Click "Setup WS-M” and wait until the action completes successfully.
For supported WS-M payload capture services see IDG WS-M payload capture support.
Click on "Record Payload" to go to open the payload capture page where you can start capturing payloads

...

...

...

Certificate Monitor (Optional)

Under "Certificate Monitor", click "Setup Certificate Monitor for Device” and wait until the action completes successfully.
Consult Consult the System Parameters List for information regarding the time interval parameter.

Domain Level Configuration

Configuring a specific domain (Optional)

1. Navigate to the domain setup page  [Manage→ Devices→ Monitored Devices]
2. Click the device name
3. Click the domain name
4. Click "Setup”
    

...

Syslog setup (Optional)

Under "Syslog Setup", select the correct Syslog Agent according to the architecture design, click "Setup Syslog" and wait until the action completes successfully.

WS-M setup (Optional)

Under "WS-M Setup", click "Setup WS-M" and wait until the action completes successfully.

WS-M Subscription (Optional)

Under "WS-M Subscription", select the correct WS-M Agent according to the architecture design, click "Subscribe to WS-M” and wait until the action completes successfully.
Only one subscription from DPOD can be enabled per domain at a time.
For supported WS-M payload capture services see IDG WS-M payload capture support

Extended Transaction setup for all services (Optional)

Under "Extended Transaction Setup for All Services", click "Setup Extended Transaction for all services” and wait until the action completes successfully.

...