Page Comparison

Setup Syslog for device

Sets up the necessary configuration for the device to send device-level Syslog records to the selected agent.
This configuration should be executed once after installing the system or when you need to redirect the device-level Syslog messages to a different agent.
To setup the Syslog for a device, select a Syslog Agent from the drop-down list, and click the Setup Syslog for device button.

You can disable/enable this Syslog target by clicking on the "Device Syslog Status" Enabled/Disabled buttons.

Limitation: DPOD does not support transactions in the default domain. See /wiki/spaces/MS/pages/9306256.

Note: This action changes your device configuration - please review changes .

Setup Syslog for all domains

Sets up the necessary configuration for all the domains to send domain-level Syslog records to the selected agent.
This configuration should be executed once after installing the system, when a new domain is created or when you need to redirect the device-level Syslog messages to a different agent.
To setup the Syslog log targets for all domains, select a Syslog Agent from the drop-down list, select analysis level from the drop-down list, and click the Setup Syslog for all domains button button.

You can disable/enable all these Syslog log targets by clicking on the "Domains Syslog Status" Enabled/Disabled buttons.

Limitation: DPOD does not support more than 125 domains per device. See /wiki/spaces/MS/pages/9306256 .

Trying to run this action on more than 125 domains can be unpredictable.

If you have more than 125 domains, you MUST run "Setup Syslog" using the Domain Level procedure below.

Note: This action changes your device configuration - please review changes .

This feature will automatically detect and setup new domains created on the monitored device, this is especially useful for dynamically created API Connect domains.

Choose a Syslog agent that the domains should report to, select analysis level from the drop-down list, enter the domain pattern (use asterisk as wildcard) and click save.
DPOD will scan the monitored device every 2 minutes and will setup the new domain (you can change the interval from the system parameters page. A UI service
restart is required after changing this interval)

Setup WS-M for all domains

Sets up the necessary configuration for all the domains to send payload data to the selected agent
This configuration should be executed once after installing the system, when a new domain is created or when you need to redirect the payloads to a different agent

Clicking the "Record Payload" link will take you to the Payload Capture page, where you can start a WS-M subscription.

Note: This action changes your device configuration - please review changes .

Note: This action does not enable the WS-M Agent on IDG. For security reasons, this can only be done from IDG.

Setup Extended Transactions for device

Extended Transactions are used to track cross-machine transactions, i.e. messages which are forwarded from one monitored DataPower Gateway to another.
To use Extended Transactions, the devices must be configured (at device level). Extended transactions can be configured through the Web Console.

Note: This action changes your device configuration - please review changes .

Setup Certificate Monitor for device

The Certificate Monitor is used to provide alerts before certificate expiration. Each device must be configured (at the device level) to enable certificate expiry alerts.
This configuration should be executed once after installing the system.

Note: This action changes your device configuration - please review changes .