Page Comparison

Setup Syslog

Sets up the necessary configuration for this domain to send domain-level Syslog records to the selected agent.
This configuration should be executed once after installing the system, or when the domain-level Syslog messages need to be redirected to a different agent.
To setup the log targets for this domain, select a Syslog Agent from the drop-down list, select analysis level from the drop-down list, and click the Setup Syslog button.

You can disable/enable this Syslog log target by clicking on the "Domain Syslog Status" Enabled/Disabled buttons.

Note: This action changes your gateway configuration - please review changes.

Setup WS-M

Sets up the necessary configuration for all the domains to send payload data to the selected agent.
This configuration should be executed once after installing the system, when a new domain is created or when the payloads need to be redirected to a different agent.

Clicking the "Record Payload" link will take you to the Payload Capture page, where you can start a WS-M subscription.

Note: This action changes your gateway configuration - please review changes.

Note: This action does not enable the WS-M Agent on IDG. For security reasons, this can only be done from IDG.

Setup API ProbeThis is only supported for API-C domains.

Sets up API Probe Settings to allow API-C debug-level data capturing per policy from the monitored device for advanced troubleshooting.
Clicking on the “Setup API Probe” button will allow you to choose from a list of predefined Gateway Peerings of this API-C domain.
Note: API Probe Settings should have a unique Gateway Peering therefore before configuring the API Probe Settings, it is necessary to configure a Gateway Peering and enable REST Management Interface.

Note: This action changes your gateway configuration - please review changes.