Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Cell Manager Installation

Prerequisites

  • Make sure to meet the prerequisites listed at the top of this page.
  • Install the following software package (RPM) on the cell manager: bc

...

Install DPOD as described in one of the following installation procedures:

  • For Appliance Mode: Appliance Installation
    • In this mode, during the installation the user is prompted to choose the data disk type (SSD / non SSD). Choose the cell members disk type (should be SSD) instead of the cell manager disk type.
  • For Non-appliance Mode: Non-Appliance Installation
    • As described in the prerequisites section, the cell manager should have two network interfaces.
      In this mode, the user is prompted to choose the IP address for the Web Console. Choose the IP address of the external network interface. 


After DPOD installation is complete, the user should execute the following operating system performance optimization script:

...

Note
Important !!  The initial installation (until the federation process is executed) of both Cell Manager and Cell Members is a standard All-In-One standalone DPOD installation .
In order for the initial installation to complete successful  all per-requisites for DPOD installation should be met as described on Hardware and Software Requirements  and Prepare Pre-Installed Operating System (including the 3 disk drives)

Prerequisites

  • DPOD federated cell member (FCM) should be installed in Non-appliance Mode with High_20dv architecture type, as detailed in the Hardware and Software RequirementsMake sure to meet the prerequisites listed at the top of this page.
  • Install the following software package (RPM) on the cell member: bc
  • The following software packages (RPMs) are recommended for system maintenance and troubleshooting, but are not required: telnet client, net-tools, iftop, tcpdump, pciutils, nvme-cli

Installation

DPOD Installation

...

  • Use Non-

...

...


  • This installation (before the federation process is executed later) is similar to a standard All-In-One standalone DPOD installation. In order for this installation to complete successfully, all prerequisites for DPOD installation should be met as described in the installation procedure, including the 3 disk drives requirement.
  • As described in the prerequisites section, the

...

  • cell member should have two network interfaces.

...

  • During the installation the user

...

  • is prompted to choose the IP address for

...

  • the Web Console. Choose the IP address of the external network interface (although the FCM does not run the Web Console service).
  • The four-letter Installation Environment Name should be identical to the one that was chosen during the Cell Manager installation.


After DPOD installation is complete, the user should execute the following operating system performance optimization script:

Code Block
themeRDark
/app/scripts/tune-os-parameters.sh

...