Versions Compared

Old Version 14

changes.mady.by.user Avi Falah

Saved on

compared with

New Version 15

changes.mady.by.user Assaf Cohen (Deactivated)

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Alerts

Alert if more than 5 API Connect API calls finished with latency of over 100ms
Change 5 to any other number using the field "Error Threshold"
To change "100" to any other latency, you will need to edit the JSON - duplicate the alert first, as system predefined alerts' JSON cannot be edited
NameDescriptionAPI Latency Above 100ms AlertTypeDescription
About to Expire Certificates AlertGatewayAlert for certificates that are about to expire. The alert will check for syslog message with code 0x806000e2 that were written in the last 24 hours
Already Expired Certificates AlertGatewayAlert for certificates that already expired - the alert will check for syslog messages with code 0x806000e1 that were written in the last 24 hours
Domain Restarts AlertGatewayAlert on domain restarts
Message Codes Frequency AlertGatewayAlert when message codes frequency exceeds threshold value
Number of Probes AlertGatewayAlert if more than 1000 transactions with probles were run in the last 10 minutes
Objects Down AlertGatewayAlert on all the DataPower objects that are enabled in configuration but in a down state (similar to the data shown in the Failed Objects page)
Syslog Errors MessageCode AlertGateway

Alert when a specific syslog message is written (only messages with severity = error)
You will need to edit this alert and enter the message codes to alert on instead of the supplied sample message code (0x81000098)

Transaction Errors AlertGatewayAlert when 5 or more transactions with errors ran in the last 30 minutes
Please note: When duplicating this alert - the new alert name must start with "Transaction_Errors" (e.g. "Transaction_Errors_2") 
API Latency Above 100ms AlertAPI-CAlert if more than 5 API Connect API calls finished with latency of over 100ms
Change 5 to any other number using the field "Error Threshold"
To change "100" to any other latency, you will need to edit the JSON - duplicate the alert first, as system predefined alerts' JSON cannot be edited
APIs That Ended in Error Code RangeAPI-CAlert on any API transaction that ended with status code 500.
You may change the range of the status code by editing the parameters JSON (for example, alert on statusCode between 300 and 600)

System Health Metrics

See System Health for more detailes

...